Bridge 2 reflects an IP and connected but no signal received

Network Audio
1

Greetings, I have a Perfectwave DAC II with a Bridge 2 installed. The Bridge indicates that it is locked onto an IP (192.168.x.x) and connected. FW 3.6.86. I have power cycled the PW and power cycled the cisco switch it is connected to. Roon does not see it over IP (not does anything else). I have an Amplifi HD router with FW 3.4.4. and the app does see it. I reset the lease via the router and that had no impact with the identical IP. Any other steps to resolve this would be helpful. Thank you!

2

Have you tried pinging the Bridge with its IP address to see if your computer can see it?

3

Used the MacOS Network utility to scan and these were the results:

Port Scan has started…

Port Scanning host: 192.168.XXX.XXX

 Open TCP Port: 	8080   		http-alt
 Open TCP Port: 	10011
 Open TCP Port: 	10015
 Open TCP Port: 	38400
 Open TCP Port: 	41460

Port Scan has completed…

4

Also did this as well:

— 192.168.xxx.xxx ping statistics —

10 packets transmitted, 10 packets received, 0.0% packet loss

round-trip min/avg/max/stddev = 0.516/0.673/0.923/0.105 ms

5

Figured it out (I hope). The Roon 1.8 defaults had the Bridge 2 as a MQA Renderer/Decoder. Once I switched that off it all sprung back to life

6

Thanks for letting us know. This is helpful info!