Hi,
I’ve just received delivery of my P10, and am familiarizing myself with it’s touch screen UI. I noticed something strange in SETUP mode - from screen #1 (GENERAL SETUP), if I use press right arrow repeatedly, the screen would display ZONE A,B,C… screens with the correct default outlet names:
ZONE A: OUTLET 1 = “OUTLET 1”, OUTLET 2 = “OUTLET 2”
ZONE B: OUTLET 1 = “OUTLET 3”, OUTLET 2 = “OUTLET 4”
ZONE C: OUTLET 1 = “OUTLET 5”, OUTLET 2 = “OUTLET 6”
etc
However if I browse using the left arrow instead, the outlet names in the ZONE screens will be all messed up:
ZONE E: OUTLET 1 = “OUTLET 9”, OUTLET 2 = “ ”
ZONE D: OUTLET 1 = “OUTLET 7”, OUTLET 2 = “OUTLET 10”
ZONE C: OUTLET 1 = “OUTLET 5”, OUTLET 2 = “OUTLET 8”
ZONE B: OUTLET 1 = “OUTLET 3”, OUTLET 2 = “OUTLET 6”
ZONE A: OUTLET 1 = “OUTLET 1”, OUTLET 2 = “OUTLET 4”
If I then press right arrow again in the ZONE A screen, then I’ll get a different combination of outlet names, but still not the same as the default names:
ZONE B: OUTLET 1 = “OUTLET 3”, OUTLET 2 = “OUTLET 2”
ZONE C: OUTLET 1 = “OUTLET 5”, OUTLET 2 = “OUTLET 4”
ZONE D: OUTLET 1 = “OUTLET 7”, OUTLET 2 = “OUTLET 6”
ZONE E: OUTLET 1 = “OUTLET 9”, OUTLET 2 = “OUTLET 8”
Is this a firmware bug? The firmware version on my P10 is 0.00.41.
Thanks.