Hi, I have the new P10 last week and want to setup the output voltage to 105v for my Japan amp, pre-amp and CD player. After I setup the output voltage to 105v in Setup screen; then check the Status, found out the output voltage in Status Screen is 110v! Is it suppose to be showed 105v, right? …

Did you purchase a Japanese version or a US version and trying to use it in Japan?

Hi Paul, Purchased the P10 is US version, I am live in CA. My city input voltage is 120v. I have Japanese version power-amp (100v) etc. Last night I tried to power off and power on the P10, after power on, I check the Status Screen, can see the output voltage first is 106v, then 10 sec later, ch…

If you go to the scope and then arrow through to the last page where you can set the voltage, it should go to 105 and stay there. The only reason I can think of that it won’t stay there is if you have it in the low distortion mode. The low distortion mode allows the output voltage to fluctuate sligh…

Hi Paul, You are right. After I set the Mode to “High regulation”, then on the Status Screen the output voltage now is 105v! After set to High regulation mode, the Scope output waveform not as perfect as when in “Low distortion” mode. Now in my Status Screen: Input voltage is 121.4v Output vol…

Reviving an old thread: I find that by adjusting phase tune the THD out drops to 0.1-0.2% even with 3.0% THD in.

I don’t find any mention of a calibration page in the manual nor on the display of my P10.

I accessed mine accidentally, by pushing the spot in the upper R corner (of the page where the “i” in the circle icon appears) TWICE in moderately-paced succession.

I don’t seem to have a page with an i in a circle. My incoming VAC is plus 0.2V from measured using Fluke voltmeter. Close enough.

P10 output voltage setup question to 105v

Power Components

John_H January 9, 2019, 6:39am 10

You may also want to pay attention and make adjustments through the calibration display page to ensure that the input and output voltages track the actual voltages.

Topic		Replies	Views
P10 shows strange values Power Components	10	693	August 2, 2020
P10 output voltage Power Components	4	444	December 1, 2021
P10 wrong voltage out and higher THD out Power Components	11	1445	January 29, 2018
P10 Power Plant Voltage regulation Power Components	5	1549	November 22, 2015
What is lowest output voltage can be set on P10 Power Components	17	2278	May 11, 2017

P10 output voltage setup question to 105v

Related topics